A neat solution for covering the rear of a stepper motor. These covers provide are made of a durable plastic and provide a secure 4-pin connector interface to your motor. An internal hub provides protection to the motor wiring protection for motors with a rear shaft.

Makes for a neat and professional looking machine.

Features:

• Quality made of a durable plastic
• Easily mounts using the motor's existing screw holes (see installation guide  for more info)
• Standard covers provide IP40 protection
• IP65 (o-ring gasket, water resistant) covers also available.
• Suitable for both motors with or without rear shaft.
• Incorporates a sleeve protecting the rear shaft of a motor from interfering with the wiring.
• Comes with pre-drilled centre marks for fast and easy drilling of the mounting holes to suit the motor.

 
Each kit IP40 with connector contains: 1 motor cover, 4 M3x25 mounting screws, 1 panel mount 4-pin connector and 1 mating cable end 4-pin connector. IP65 and IP40 covers come with no connector and the covers are not predrilled for a connector, the IP65 covers include o-ring gasket, you must use a glad nut or sealed connector to maintain IP65 rating.

NOTE: These covers DO NOT fit 60mm square frame steppers, which are sold by KelingInc as "NEMA23" size. A true NEMA23 should be about 2 1/4" square.

Downloads:

Sizing guide
Installation instructions